Teejet Legacy 6000 Manual Instrukcja Użytkownika Pobierz pdf (Strona 41)

Chapter 2 - System Overview36

Monitor Selection

A monitor is used to observe the status of an application delivery system element

(e.g., RPMs on a shaft sensor) and is not used for any control type function. Up to

four monitor sensors may be used in the delivery system. The monitor types avail-

able (refer to Table 2-17) are based on the Application, Primary Sensor, and Sec-

ondary Sensor types selected. Each monitor type will have an associated Settings

softkey that launches the Monitor Settings page. The Monitor Sensor parameters

are dependent upon the type of Monitor Sensor selected.

Channel Setup contains four Monitor Setup pages (Monitors 1 - 4). It is not neces-

sarytocongurefourmonitors.Selectthemonitor(s)usedandpresstheForward

Arrow softkey to save the settings. If there is no monitor, select the “None” setting

and continue to the next page.

Figure 2-30: Monitor Page

Table 2-17: Monitor Options

Settings Description

Shaft Monitors shaft rotation speed.

Product Detect Monitors the On/Off Status of a product (e.g., Chemical Flow Monitor of an Injection Pump).

Low Bin Monitors low product level.

Status Monitors engaged or disengaged status.

Pressure Digital Monitors pressure related or not related to application.

Pressure Analog Monitors pressure related or not related to application.

Flowmeter Monitorsowofliquidusingaowmeter.

Spread Switch The sensor detects if the spread switch is on. This sensor is required for operation without a

CAN Switch Box or ISM, and can only be used with a one-section implement.

Settings softkey

(F2)

Forward Arrow

softkey (F6)

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 158 159

Brak uwag

Teejet Legacy 6000 Manual Instrukcja Użytkownika Strona 41